mccullpl
Well-Known Member
I just got a MM-2 from Midwest, along with the base and hopper. When I opened the box, I notices little metal chips on everything. Opened up the mill, and noticed the rollers had slipped out of the end block, and were probably banging against each other during shipping. I spent about 45 minutes trying to get all the little metal chips off the roller, and finally gave up and called Midwest. They said they'd happily replace it when they got more in stock. Before I send it back, I wanted to see if this was typical, and if I should just clean it a bit more and keep it. The rollers themselves don't look to be damaged from contacting each other, but it does look like there is a small divot where the points on the knurling should be. It's very uniform, so I doubt this was a result of the rollers hitting each other. I've seen others post pics of this, and I remember the consensus being that they should have a point, and to send it back. Am I being too anal about this?
Thanks in advance!
Pat
Thanks in advance!
Pat