floridabrewer
New Member
On 10-07-05 I told anyone interested about the $9 garden hose type water pump that will run off your drill motor for transfering your cooling water through your 3/8" copper cooling coil. Remember this....... you must cilp or duct tape or something to hold the tube intake end a few inches from the end in the ice water container. AND>>>>DO NOT WALK AWAY FROM YOUR WORT COOLING TO SEE WHAT THE WIFE IS CALLING YOU FOR !! If it falls out you have no water intake and will burn the little pump right up if the water "in" end is not drawing the cold water ! ( It took only about 1 minute with no water to burn it up!) So lessen learned here, it worked very well before I burned the pump up from no water going through it ! I finsihed the wort cooling as I was told in this forum earlier by you folks by hooking up the garden hose directly to the coil in a big hurry! Either method it cooled very fast. I could taste the difference in the cooled wort from my old ways. Thank you all for that to!
Oh Well! The beer is doing fine at this point of fermentation.
Oh Well! The beer is doing fine at this point of fermentation.