Mutilated1
Beer Drenched Executioner
I built a MLT out of a cooler with the instructions on the forum, and the first 5-6 batches I made turned out great. When I opened the spigot, the MLT drained right into the pot.
The last few batches I've tried, the flow of wort out of the spigot has been very slow, just a trickle, and I think its getting worse each batch.
Is there some maintenace that needs to be done ?
I was thinking of cutting a couple inches off my stainless steel braid and reattaching it because the briad is sort of worn out near where it clamps to the hardware.
Not only is it slower than it used to be, I think my efficiency is not as good as it once was, though I'm not sure what that would have to do with the MLT draining slowly.
The last few batches I've tried, the flow of wort out of the spigot has been very slow, just a trickle, and I think its getting worse each batch.
Is there some maintenace that needs to be done ?
I was thinking of cutting a couple inches off my stainless steel braid and reattaching it because the briad is sort of worn out near where it clamps to the hardware.
Not only is it slower than it used to be, I think my efficiency is not as good as it once was, though I'm not sure what that would have to do with the MLT draining slowly.