RockfordWhite
Well-Known Member
- Joined
- Dec 3, 2007
- Messages
- 473
- Reaction score
- 11
So in building my eHLT I just noticed that there are no positive or negative markers on the heating element... any suggestions?
What do you use to stir it for consistent temps?
Exactly as Yuri said, if you run a 220V element at 110V it will give you only 1/4 of the rated power. If it's designed for 4500W@220V it'll do 1125W@110V drawing 10A which is fine for average household breakers. But it's for you to decide if 1125W is going to be enough heat for your system.It's designed for 220...i thought it was 4500... could be 5500... is that gonna trip my circuit breaker? Should i get a new element?
Enter your email address to join: