southpawbrew
Well-Known Member
I was wiring up my new tri-clover RIMS from Brewer's Hardware and I changed from a LWD 110 heating element to a LWD 220 element that I am running on 110. I built a control box straight copied from Boerderij_Kabouter click here to see it
The weird problem that came up was the PID reads say 70 then when I have the element off then when I switch on the element it will drop instantly to say 51. Nothing else changed. I went through the box to make sure nothing was out of place.
Any suggestions on where I should check or changes in the wiring I need to do?
The weird problem that came up was the PID reads say 70 then when I have the element off then when I switch on the element it will drop instantly to say 51. Nothing else changed. I went through the box to make sure nothing was out of place.
Any suggestions on where I should check or changes in the wiring I need to do?