maltoftheearth
Well-Known Member
Before I drive 60 miles one way to get this problem checked at MLHBS I thought maybe folks here would have some advice.
Last night I intended to keg for the first time. Hooked everything up, the CO2 is working b/c the release valve on the keg is able to release CO2 after I have added it. The problem is that my "Out" pin is not distributing liquid (I tested with SaniStar) through to the tap.
I can press down on the "Out" pin and I hear CO2 escaping so I assume the problem is the connection between the "Out" pin and the piece that connects it with the tap line.
Any suggestions of what else (besides mechanical failure) is going on here?
Last night I intended to keg for the first time. Hooked everything up, the CO2 is working b/c the release valve on the keg is able to release CO2 after I have added it. The problem is that my "Out" pin is not distributing liquid (I tested with SaniStar) through to the tap.
I can press down on the "Out" pin and I hear CO2 escaping so I assume the problem is the connection between the "Out" pin and the piece that connects it with the tap line.
Any suggestions of what else (besides mechanical failure) is going on here?