Hey guys, this might seem like a dumb question, but I just built an immersion chiller today out of 1/2" ID flexible copper pipe and I was wondering ... how do you get the water out of it when you are done? I just did a test run and it worked great, but now I can't get the water out of the chiller ... is it okay for it to just sit in there?
Oh and I used a bit larger pipe than you guys usually do since Home Depot didn't have any 3/8" elbows. My coil ended up being pretty tall, which isn't really a bad thing since I have a 20 gallon pot. Shouldn't be a big deal, right?
Buddy
Oh and I used a bit larger pipe than you guys usually do since Home Depot didn't have any 3/8" elbows. My coil ended up being pretty tall, which isn't really a bad thing since I have a 20 gallon pot. Shouldn't be a big deal, right?
Buddy