Beer forced through my keg out line

Hello, I searched for an answer to this issue to no avail so here goes:

My beer is kegged and chilled to about 41F. I hooked up the co2 lines and put the pressure at about 9psi. Immediately the beer was being forced through the out line and out of my spout! I removed the out line and let it set all day (12 hours) and when I hooked the out line up and it did the same thing.

What is going on? Is the keg bad? Am I bad ? Any ideas here?

Close the spout/faucet.

ODaniel said:

Close the spout/faucet.

Click to expand...

So I read this and thought "haha, of course it's closed!"
BUT, I went and checked just to be sure, and it turns out that the top of the spout wasn't completely screwed on. OMG

Ok, thanks so helping me in my retardedness.

Had a poppet spring break once and pressure would slowly open faucet friends thought there was a ghost was drinking..........disconnect gas and relief valve before checking poppet on liquid side.......trust me on this

ooguyx said:

So I read this and thought "haha, of course it's closed!"
BUT, I went and checked just to be sure, and it turns out that the top of the spout wasn't completely screwed on. OMG

Ok, thanks so helping me in my retardedness.

Click to expand...

Hah it happens.