So after measuring like 5 times and cutting once, I still managed to mess this up (I'm not a savvy woodworker apparently).
I was hoping to do a double-walled keezer collar with some "lesser" wood on the inside and a larger over-hanging lip with nicer wood on the outside. Lid to be attached to collar so I can lift the taps out of the way. I ended up coming short on the cuts, as seen here:
Is there any way to save this mistake?
I was hoping to do a double-walled keezer collar with some "lesser" wood on the inside and a larger over-hanging lip with nicer wood on the outside. Lid to be attached to collar so I can lift the taps out of the way. I ended up coming short on the cuts, as seen here:
Is there any way to save this mistake?