Kord78
Active Member
Morning all!
I need some help here as I am trying to figure out how to make a sealed square tube for propane dispersion to two honeywell valves. So what I need to know is:
- What size/type input port to mount on the sq. tube so that I can hook a propane tank up to it.
- If I am using a 30 PSI propane tank (standard grill propane tank correct?) what size honeywell valves could I use? - I was thinking 1/4" in/out? Do they make those? I have found 1/2" valve assemblies, but no 1/4". Lastly, do I need special couplers for these or do I just mount 1/4" OD threaded pipe to the tube?
Any input on this would be great.
Thanks all!
The attached image shows the basic structure that I would run with. The "threaded" bumps outs are all 3/4" long and are just there for example purposes.
I need some help here as I am trying to figure out how to make a sealed square tube for propane dispersion to two honeywell valves. So what I need to know is:
- What size/type input port to mount on the sq. tube so that I can hook a propane tank up to it.
- If I am using a 30 PSI propane tank (standard grill propane tank correct?) what size honeywell valves could I use? - I was thinking 1/4" in/out? Do they make those? I have found 1/2" valve assemblies, but no 1/4". Lastly, do I need special couplers for these or do I just mount 1/4" OD threaded pipe to the tube?
Any input on this would be great.
Thanks all!
The attached image shows the basic structure that I would run with. The "threaded" bumps outs are all 3/4" long and are just there for example purposes.