Searched and found little on this topic. Sage advice would be appreciated.
Moving from a steel braid to a cpvc manifold in my mash tun. No particular reason, just bored and curious about how the two will stack up as far as efficiency.
Should I cut the slots on the bottom or top of the cpvc? My thoughts are as follows. If I cut the slots on top there is more dead space and the potential for the slots to get clogged (more dead space effecting efficiency being more important here). If I cut the slots on the bottom it will effect flow.
Right now I'm thinking about alternating my slots left and right of center on the bottom of the cpvc and have it lay on the bottom of the converted cooler.
Thoughts?
Moving from a steel braid to a cpvc manifold in my mash tun. No particular reason, just bored and curious about how the two will stack up as far as efficiency.
Should I cut the slots on the bottom or top of the cpvc? My thoughts are as follows. If I cut the slots on top there is more dead space and the potential for the slots to get clogged (more dead space effecting efficiency being more important here). If I cut the slots on the bottom it will effect flow.
Right now I'm thinking about alternating my slots left and right of center on the bottom of the cpvc and have it lay on the bottom of the converted cooler.
Thoughts?