I need about fifteen fittings, mostly Tee, mostly 3/4" OD. Cruising the interwebs for these is very discouraging, the prices are insane! I haven't found a 3/4" OD tee for under $150. St. Pats has 1" OD tees for $21, so I would expect to find 3/4" for less than that.
Should I give up and resize my brewery to 1" throughout? That would suck since my pump inlets/outlets and my kettle inlets are all 3/4".
Should I give up and resize my brewery to 1" throughout? That would suck since my pump inlets/outlets and my kettle inlets are all 3/4".