what fitting to attach burner to 1/2" black pipe?

Hi all. I'm building a single-tier brewstand A LA brutus 10, and I think I'd like to use the el cheapo high-pressure burners listed here

http://www.agrisupply.com/cast-iron-burner-com-/p/30295/cn/5400001/

Any idea what fitting is best to use to plumb these to 1/2" black pipe for the gas manifold?

Any ideas appreciated...

My manifold is 3/8" with a bell reducer from 1/2" to 3/8". But, I also just use a umbilical with a NG QD from Dortman fittings.

I used 1/4" soft copper with needle valves and reducer bushings.

It works like a charm and allows full regulation of flame height.

I used yellow flex hose from true value. Check it out.

I used flared 3/8 copper tubing.

are you guys using propane? or natural gas?

My red stand above uses propane. I have 3 banjos and a red 0-30 psi regulator for high pressure. I get 3 brews w/90 minute boils on one tank, average. I have to adjust my regulator as I look at the flame on initial startup sometimes but overall thats it. Good system and works fine. If I were to change anything it would be better pilot lights, which I made myself by drilling out some brass end caps with a couple of tiny holes.
snake10

Nice pics! Mind if I mind asking what kind of orifices you used to the burner, and what kind of flared fittings? Also, is that just a plain regular ball valve, or is it a needle valve.

Thanks.

The jet came from MoreBeer:
http://morebeer.com/view_product/7684//High_Pressure_Propane_Jet_for_H205

All the 3/8 flare fittings I got at Lowes. I'm just using ball valves, but needle valves would probably give more control