Croy9000
Well-Known Member
I wanted to get opinions on this MT manifold I built yesterday.
Some concerns I have are:
1. I used a chop saw to cut the slits, but now worry the opening of the slit may be too wide. They measure 1/8". Do you think that will let in too much crud? Maybe I should remake them with just a hacksaw blade?
2. That long span of clear tubing may get crushed under the weight of the mash. Although I am only doing 5 gallon batches.
Any thoughts?
Some concerns I have are:
1. I used a chop saw to cut the slits, but now worry the opening of the slit may be too wide. They measure 1/8". Do you think that will let in too much crud? Maybe I should remake them with just a hacksaw blade?
2. That long span of clear tubing may get crushed under the weight of the mash. Although I am only doing 5 gallon batches.
Any thoughts?