I just bought a micromatic line cleaning kit, since my lines run through the wall it is tough for me to take the lines out to clean them. One problem I have though is I cannot pump the soulution through the lines because of the ball lock disconnects on the end of the line. does anyone know of a way to push in the little pin inside so the solution can flow?
Using the micromatic line cleaner
- Thread starter Homer
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
Either install an empty cornie and pump into that or on the top of the QD there is a screw driver slot that allows disassembly for cleaning. (dont loss the seals or spring.)
wildwest450
Well-Known Member
- Joined
- Dec 27, 2007
- Messages
- 8,978
- Reaction score
- 191
I unscrew the top as mentioned and put the guts in a small tupperware container along with the tap and it's guts. Then I pump half the solution through, or enough so the disconnect and tap is submerged, let sit for 15 minutes then rinse and re-install.
