SAMPLER
Well-Known Member
Anyone mind helping me out wire my new Auber JSL-71 timer with a reset button? I'm looking to install a reset button but can't figure it how. Simple I'm sure but help is appreciated.
Cheers
Cheers
HELP!
I wired my auber syl-71 timer and i have power and the reset button works but as soon as I throw the switch to turn in the alarm and buzzer everything lights up and the buzzer goes off even when the timer is not active. My wiring send good but why does it do this? Note the buzzer and lights go of when i throw the alarm switch on either of the PID's too.*Any suggestions or anyone care to post a picture of your wiring set up.*
Cheers
HELP!
I wired my auber syl-71 timer and i have power and the reset button works but as soon as I throw the switch to turn in the alarm and buzzer everything lights up and the buzzer goes off even when the timer is not active. My wiring send good but why does it do this? Note the buzzer and lights go of when i throw the alarm switch on either of the PID's too.*Any suggestions or anyone care to post a picture of your wiring set up.*
Cheers
There are 2 different versions of the JSL-71 timer. The wiring plan that I provided here in another thread is the older wiring plan. If you recently purchased the timer, the wiring plan has changed.HELP!
I wired my auber syl-71 timer and i have power and the reset button works but as soon as I throw the switch to turn in the alarm and buzzer everything lights up and the buzzer goes off even when the timer is not active. My wiring send good but why does it do this? Note the buzzer and lights go of when i throw the alarm switch on either of the PID's too.*Any suggestions or anyone care to post a picture of your wiring set up.*
Cheers
Do you have an external alarm on/off switch? I went back and forth with Auber via e-mail as I was frustrated that there is no way to simply stop/reset the alarm relay once the timer has counted down. If you hit "reset", it stops the alarm but then the timer starts counting down again. If you hit "stop" in the middle of it counting down, it triggers the alarm relay. You can program it so T2 has an alarm off delay but then you lose the ability to use T2 and a second preset time option.
Luckily I have an external alarm on/off switch so I can at least stop the light/buzzer. I just wish there was any easy way to reset this timer back to the state its in when you first power it on (not counting down, no alarm out relay, etc.).
Auber has offered to reprogram it to have a reset that actually resets it without it starting to count down again and will do it for free if enough people are on board.
Enter your email address to join: