drdingo
Member
Just got done building my first kegarator (converted a sanyo). I only have 1 1/6 keg in there for now.
When I connected everything together I had the CO2 turned off by the little red switch. Once I tapped the keg I pulled the little release on the coupler to drain the CO2 out of the keg - I read somewhere that's what you are supposed to do...
Now the keg is foamy (which I assume is because of the high temp of it - 58*) but it is also flat.
Am I just being paranoid and once everything cools down it will be fine? Or should I have not released the pressure from the keg? Is there anything I should do?
Thanks!
When I connected everything together I had the CO2 turned off by the little red switch. Once I tapped the keg I pulled the little release on the coupler to drain the CO2 out of the keg - I read somewhere that's what you are supposed to do...
Now the keg is foamy (which I assume is because of the high temp of it - 58*) but it is also flat.
Am I just being paranoid and once everything cools down it will be fine? Or should I have not released the pressure from the keg? Is there anything I should do?
Thanks!