ok today shoulda been great going out and getting everything for my mash tun but . . . I got all the stuff for the manifold and will pull my hair out about the bulkhead fitting tomarrow.
ANYWAY, I'm sittinghere looking at my cooler, and the inside measurments are 19" X 11.5" and 11.5" deep. How far from the sides of the cooler should my tubes be? I thought I read somewhere that the tubes should be one half of the distance from each other to the sides.
So if I figure this right and I am using a rectangle with only 2 long tubes and 2 short I'm looking at the long tubes being 3 inches from the side and 6 inches between then and the short tubes being about 5 inches from the sides and 10 inches apart? Roughly, I'm not gonna worry about a fraction of an inch.
ANYWAY, I'm sittinghere looking at my cooler, and the inside measurments are 19" X 11.5" and 11.5" deep. How far from the sides of the cooler should my tubes be? I thought I read somewhere that the tubes should be one half of the distance from each other to the sides.
So if I figure this right and I am using a rectangle with only 2 long tubes and 2 short I'm looking at the long tubes being 3 inches from the side and 6 inches between then and the short tubes being about 5 inches from the sides and 10 inches apart? Roughly, I'm not gonna worry about a fraction of an inch.