Wiring my Love TS-13010

Need help wiring my Keezer to a Love TS-13010. There's a web site out there with instructions, but there are two (different) sets of them...

http://blog.flaminio.net/blogs/index.php/beer/gadgets/wiring_love_ts_controller
http://blog.flaminio.net/blogs/index.php/beer/gadgets/love-ts-13010-temperature-switch-new-wir-2008

... and neither looks like it matches the little diagram on the spec sheet that came with the controller. Here's what the spec sheet shows, put into a 'text' description...

7 - Power Supply
8 - Power Supply
9 - NC
10 - COM
11 - NO

I assume 7 and 8 would be Neutral and Hot from the wall. But what about 9, 10, and 11? TIA!

---VikeMan

The second diagram is what you want.

When the temperature goes above the set point, the relay will close and the power in (pin 10) will be sent to pin 11, turning on the compressor.

NC means "normally closed" while NO means "normally open".