ToastedPenguin
Well-Known Member
Are there any quick disconnects that can be used with the plumbing for Co2?
I would like to be able to remove the gas lines from my barbed regulator so I can move the tank with the regulator connected away from my keezer temporarily and use co2 to push beer from my sanke keg fermenters or into my corny kegs for serving etc.
I figured I could add a small length of hose to the regulator and put a swivel nut on the end and then put another swivel nut on the end that connects to my keezer as well as the setup I am using to push gas when racking my beer, however I can't find anything that I could use to join the 2 swivel nut ends.
So I am looking for something I can use as a union for the 2 swivel nuts or something else that provides a similar quick disconnect for my co2 lines.
Thanks!
David
I would like to be able to remove the gas lines from my barbed regulator so I can move the tank with the regulator connected away from my keezer temporarily and use co2 to push beer from my sanke keg fermenters or into my corny kegs for serving etc.
I figured I could add a small length of hose to the regulator and put a swivel nut on the end and then put another swivel nut on the end that connects to my keezer as well as the setup I am using to push gas when racking my beer, however I can't find anything that I could use to join the 2 swivel nut ends.
So I am looking for something I can use as a union for the 2 swivel nuts or something else that provides a similar quick disconnect for my co2 lines.
Thanks!
David