shortyjacobs
Well-Known Member
This is a ball lock keg. I disassembled to clean it, and now I can't figure out how to put it back together. It's really weird. No o-rings on the dip tubes, and a ton of pieces...
Gas in threads:
Liquid out threads:
Liquid out bits, I think...the black grommet thing goes into the depression you see above...the poppet goes into the post, and I think the teflon looking thing packs in behind the poppet:
Another view:
The gas bits, I think...notice the flare and lack of o-ring on the gas tube - that fits right into the flare of the gas threads above...:
Another view..the rubber thing packs in behind the poppet in the post, I think....:
Anyone see this?? How to reassemble it?? I can't make it all quite fit...
Gas in threads:
Liquid out threads:
Liquid out bits, I think...the black grommet thing goes into the depression you see above...the poppet goes into the post, and I think the teflon looking thing packs in behind the poppet:
Another view:
The gas bits, I think...notice the flare and lack of o-ring on the gas tube - that fits right into the flare of the gas threads above...:
Another view..the rubber thing packs in behind the poppet in the post, I think....:
Anyone see this?? How to reassemble it?? I can't make it all quite fit...