bheggeseth
Active Member
I just got done soldering the fittings on my boil kettle and wont need the parts any more. I soldered 4 fittings and as you can see there is left plenty of solder left. The solder is a one pound spool of Stay Brite #8 in 1/8" size. This is the better grade of Stay Brite solder and the 1/8" size lets you place a ring of solder in the fitting and you simply heat from the bottom and the solder flows just perfect, included is the liquid flux. Also included is the stainless steel tapered fittings that are used to flare the holes. The bolt is a grade 8 bolt and the other pipe fittings are steel and are used to brace the bolt as you tighten the flaring tool. The stainless steel fittings will allow you to flare holes for 1" and 1.5" pipe. Last I am including some cutting oil. Again I only used enough for four holes. I am asking $125 plus shipping.
Thanks, Brad.
Thanks, Brad.