Corona Grain Mill

wps-hbt
Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
V

voodoochild7

Well-Known Member
Joined
Oct 14, 2005
Messages
273
Reaction score
0
Location
New Jersey
Just got a corona grain mill as my friend was giving it away. How do I ajust this thing it seems the grain is getting too pulveized or not enough. Do the screws on the side have anything to do with the adjustment or should I just tighten those all the way and use only the center adjuster? Thanks
 
There should be a nut on the outside of the rotor that will move the rotor in or out as compared to the stator. Noonan recommends a gap of .035" so I used spark plug gauges to set mine and haven't had any issues with stuck sparges.
 
Mine is the type with two clamps on either side that holde the stater with the center adjusting screw it seems that there is always one side with a gap greater that the other any tips on getting this thing close to home will be much appreciated
 

Similar threads

agentbud
Motor for Grain Mill
Replies
26
Views
1K
jerrylotto
jerrylotto
ILMSTMF
Milling grains - corded vs. cordless drill
Replies
8
Views
356
ILMSTMF
ILMSTMF
B
Grain mill with broken adjustment knob
Replies
1
Views
509
day_trippr
day_trippr
Zippy123
Does this look like a suitable grain mill?
Replies
12
Views
1K
wilserbrewer
wilserbrewer
hiphoppotamuss
What To Look For in a Grain Mill?
Replies
29
Views
1K
redrocker652002
R
Yakima 300

Latest posts

Back
Top