ceejengine
Active Member
I tried searching through the forums, but didn't have much luck (or just didn't hit on the right search terms)- so if this has already been discussed ad nauseum, my apologies!
I'm getting ready to convert my Sankey kegerator to one using Corney kegs, and have been researching what I would need. What I haven't been able to figure out is if there's a difference between going pin or ball lock. I know I need different fittings for the kegs themselves, but are there any advantages/disadvantages to going one route or another?
Thanks for the help!
I'm getting ready to convert my Sankey kegerator to one using Corney kegs, and have been researching what I would need. What I haven't been able to figure out is if there's a difference between going pin or ball lock. I know I need different fittings for the kegs themselves, but are there any advantages/disadvantages to going one route or another?
Thanks for the help!