This is an extremely noob question and I'm almost embarrassed to post it.
I'm basically trying to copy the countertop brutus using the exact same components (auber syl 2362). I'm pretty sure I have everything wired up correctly as everything is working, except maybe the PID.
I did a test run last night. I had it set up to heat and hold at 130F but the PID won't turn off the water element heater. It stayed on.
What am I doing wrong? Do I need to program the PID? How do I set the target temp?
I'm basically trying to copy the countertop brutus using the exact same components (auber syl 2362). I'm pretty sure I have everything wired up correctly as everything is working, except maybe the PID.
I did a test run last night. I had it set up to heat and hold at 130F but the PID won't turn off the water element heater. It stayed on.
What am I doing wrong? Do I need to program the PID? How do I set the target temp?