BrewBarron
Well-Known Member
Here's my latest build,
I figured I would post it because I haven't seen one built quite this way yet. It is very similiar to a lot of other chambers out there, I just went a little different route.
Instead of removing all the guts of an old frige, I just left them attached as is and opened up the fridge like a tin can and built around it. I cut the fridge at the seams on the right side on the top and bottom and swung it out to match the back of the fridge.
From there I removed the liner (it was later reinstalled) and then I started building the new footprint. I tried to save as much of the original insulation as I could and screwed the new plywood to the base of the fridge.
I figured I would post it because I haven't seen one built quite this way yet. It is very similiar to a lot of other chambers out there, I just went a little different route.
Instead of removing all the guts of an old frige, I just left them attached as is and opened up the fridge like a tin can and built around it. I cut the fridge at the seams on the right side on the top and bottom and swung it out to match the back of the fridge.
From there I removed the liner (it was later reinstalled) and then I started building the new footprint. I tried to save as much of the original insulation as I could and screwed the new plywood to the base of the fridge.