MadHaddens
Member
- Joined
- Mar 29, 2009
- Messages
- 11
- Reaction score
- 0
I attempted to keg my first batch last night. I santized the keg and forced IO through the line with CO2. Filling the keg went as I expected, then I hooked up my gas line and pressurized (set at 15 PSI), and into the fridge she went.
I checked on the setup this morning. The low pressure gauge read 0, and the high pressure gauge read about 550. I expected the pressure to decrease b/c of the temp change, but that much???
I turned off the gas, released the pressure in the keg, which was minimal, and turned the gas back on. Readings were the same, and I didn't hear any gas!
Any thoughts?
Also, I'm not supposed to hook up the beer/out line for a few days, right? What would happen if I did?
I checked on the setup this morning. The low pressure gauge read 0, and the high pressure gauge read about 550. I expected the pressure to decrease b/c of the temp change, but that much???
I turned off the gas, released the pressure in the keg, which was minimal, and turned the gas back on. Readings were the same, and I didn't hear any gas!
Any thoughts?
Also, I'm not supposed to hook up the beer/out line for a few days, right? What would happen if I did?