dunleav1
Well-Known Member
I have wired a TSS2-2100.
I have cooling hooked up to output 1 and a heater connected to outut 2.
I have the following options set on the controller.
P5=1
c1=dir
c2=inv
r0=dep
SP1=70
SP2=60
Output 2 is not working as expected.
The temperature is 65 and output 2 is getting power. Output 2 should not get power until the temperature is <= SP2 (60). I pulled terminal 11 and confirmed power is on when the temperature is 65. Why?
Output 1 works as expected, if the temperature rises to the SP1 point, output 1 goes hot.
I have the controller wired as this:
1 probe 1 wire a
2
3 probe 1 wire b
4 neutral
5 power
6
7 power
8 switched hot - cooler
9
10 power
11 switched hot - heater
I searched the threads here and I think I'm wired correct. I am missing something?
Thanks,
JD
I have cooling hooked up to output 1 and a heater connected to outut 2.
I have the following options set on the controller.
P5=1
c1=dir
c2=inv
r0=dep
SP1=70
SP2=60
Output 2 is not working as expected.
The temperature is 65 and output 2 is getting power. Output 2 should not get power until the temperature is <= SP2 (60). I pulled terminal 11 and confirmed power is on when the temperature is 65. Why?
Output 1 works as expected, if the temperature rises to the SP1 point, output 1 goes hot.
I have the controller wired as this:
1 probe 1 wire a
2
3 probe 1 wire b
4 neutral
5 power
6
7 power
8 switched hot - cooler
9
10 power
11 switched hot - heater
I searched the threads here and I think I'm wired correct. I am missing something?
Thanks,
JD