As you many know, I'm SLOWLY building my single tier stand. It's going to have three burners. The burners will be mounted on a straight piece of angle iron that is going to be run right down the middle and supported on both ends with threaded rod to make the whole assembly height adjustable until I dial in the best height. Each burner will be bolted right to the support bracket.
Oh, in case you don't remember the basic structure:
Of course, in the picture the burners are just conveniently floating.
Obviously I need to make the valves easily accessible from the front of the rig as I have no short term plans of automating. Enough of the chit chat, I need some ideas for keeping the system simple and neat, but functional. Also, long handle ball valves or the stubby ones?
Oh, in case you don't remember the basic structure:
Of course, in the picture the burners are just conveniently floating.
Obviously I need to make the valves easily accessible from the front of the rig as I have no short term plans of automating. Enough of the chit chat, I need some ideas for keeping the system simple and neat, but functional. Also, long handle ball valves or the stubby ones?