I've never worked with copper before, but I'm trying to connect a pipe to a brass bulkhead on a cooler MT. I've been following the Cheap and Easy MT thread, but I've decided to use a copper tube inside the SS braid. Is there a particular type of copper tubing I should get? Should I use a compression fitting to attach it to the brass nipple that goes through the cooler wall?
On a related note, what gauge copper wire should I wrap the tubing with?
Should I use a couple elbows to get the copper tubing closer to the bottom of the cooler?
Anything else I should be thinking about?
Note, I am not outfitted to do any soldering.
thanks!
kman
On a related note, what gauge copper wire should I wrap the tubing with?
Should I use a couple elbows to get the copper tubing closer to the bottom of the cooler?
Anything else I should be thinking about?
Note, I am not outfitted to do any soldering.
thanks!
kman