I am currently changing my 1 keg system into a 4 keg system. I need help in designing or procuring a manifold. I will be going through the side of the fridge and storing CO2 outside. My questions are:
1) Can I get by without individual guages/control for each keg? What are the downsides?
2) Any design considerations for being able to force carb one keg while the others are attached? (I like to kick the pressure up to 35psi for 3 days on new keg)
3) Any tips for avoiding leaks? (ie special connection consideration)
4) Good places to source the block manifolds and parts?
5) Connection to air line tips? (ie ditch the plastic dohickies)
I am getting the beer lines/air lines/ball valves/shank-nipples/and taps from Bevverage Factory. Also heard about quick connects for air lines instead of clamps so I wouldn't mind building those into the design.
Thanks for any advice.
1) Can I get by without individual guages/control for each keg? What are the downsides?
2) Any design considerations for being able to force carb one keg while the others are attached? (I like to kick the pressure up to 35psi for 3 days on new keg)
3) Any tips for avoiding leaks? (ie special connection consideration)
4) Good places to source the block manifolds and parts?
5) Connection to air line tips? (ie ditch the plastic dohickies)
I am getting the beer lines/air lines/ball valves/shank-nipples/and taps from Bevverage Factory. Also heard about quick connects for air lines instead of clamps so I wouldn't mind building those into the design.
Thanks for any advice.