I finally found my local artesian well report on-line, but reading through it, it seems there are some things missing: https://docs.google.com/file/d/0B4l...djZS00MGZmLWI1ZDktZmUwZDIzNGU5MzRj/edit?hl=en
It lists:
Nitrate-N .42 mg/L
Fluoride .13 mg/L
Chloride 3.6 mg/L
Sulphate 9.5 mg/L
Zinc .007 mg/L
Sodium 6.29 mg/L
Hardness (calcium carb) 164 uS/cm
Everything else is either none detected, or just not there.
Is this enough info to enter into Brewater?
Would it be better to just get a specific report from Ward?
I travel about 5 miles to get this water for free, but I also have access to RO water right here at my house... I just figured building up water from scratch would be more difficult than adjusting spring water.
Thanks for any help/opinion on which route to go.
It lists:
Nitrate-N .42 mg/L
Fluoride .13 mg/L
Chloride 3.6 mg/L
Sulphate 9.5 mg/L
Zinc .007 mg/L
Sodium 6.29 mg/L
Hardness (calcium carb) 164 uS/cm
Everything else is either none detected, or just not there.
Is this enough info to enter into Brewater?
Would it be better to just get a specific report from Ward?
I travel about 5 miles to get this water for free, but I also have access to RO water right here at my house... I just figured building up water from scratch would be more difficult than adjusting spring water.
Thanks for any help/opinion on which route to go.