I curious or the pros and cons for 1 1/2 versus 2 inch square tubing....Thanks in advance
[...]Center vertical supports do little if anything.[...]
based on experience... I built several prototypes (wanna buy a prototype?)
day_trippr, can you show your work that led you to believe that by not including a vertical support his stand is being stressed outside the elastic range? also, i don't understand how by him not welding a vert support is "defying the whole principle of elastic modulus"
also...how much for a proto stand??
One of the problems with language is so few people are skilled at using it.
blah blah
But perhaps what he really meant was there wasn't a need for vertical ties from upper to lower spans - that the upper span of a stand would have sufficient intrinsic weight-bearing capability that tying it to a lower span is unnecessary.
2BeerSpeer said:I curious or the pros and cons for 1 1/2 versus 2 inch square tubing....Thanks in advance
Lol. Bet you're sorry you asked....
so, enough material for a brutus in mild 2" steel is $84?
2BeerSpeer said:i found a cut list online with detailed plans in a pdf but I suggest ordering the back issue of byo it has a lot of info and the pics always help
1 x 2 is what MoreBeer uses. The height is the key to the design.
Enter your email address to join: