RTD pinout
- Thread starter bowhuntah
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
Lucky_Chicken
Well-Known Member
as long as your other side is wired the same I dont see a problem
The red wires go to pins 3 and 4. The white wire goes to pin 5.
^^correct.
btw the two red leads are connected together. some controllers compute the resistance of the lead wires in order to make the RTD calculations more accurate. if you measure the resistance between the two red leads, this is the number you subtract from the resistance measured between red+white leads to get an accurate reading.
btw the two red leads are connected together. some controllers compute the resistance of the lead wires in order to make the RTD calculations more accurate. if you measure the resistance between the two red leads, this is the number you subtract from the resistance measured between red+white leads to get an accurate reading.
Similar threads
