GreenMan
Well-Known Member
Three questions. One about probes and one about towers.
So I got a Frigidaire 14.8 cuft freezer for Christmas and have added the Love Controller to panel where the old controller was got it wired up and thought I would be lucky enough that the probe for the Love controller would fit where the old probe was but the tube that the old probe was in. What would be the best thing to do with the new probe? Should I just drill a hole in the compressor shelf? (the controller is in the same compartment that the compressor is in.)
I bought a 4" tower with 4 holes in it to eventually place 4 taps. I plan on using a piece of wood like Arneba28 did. What thickness of wood should I use?
And instead of drilling a 4 inch hole in the top of the freezer can I just drill 4 holes that are slightly larger then the tubing OD and shove each tap hose through each hole? Is there anything wrong with this?
Thanks.
So I got a Frigidaire 14.8 cuft freezer for Christmas and have added the Love Controller to panel where the old controller was got it wired up and thought I would be lucky enough that the probe for the Love controller would fit where the old probe was but the tube that the old probe was in. What would be the best thing to do with the new probe? Should I just drill a hole in the compressor shelf? (the controller is in the same compartment that the compressor is in.)
I bought a 4" tower with 4 holes in it to eventually place 4 taps. I plan on using a piece of wood like Arneba28 did. What thickness of wood should I use?
And instead of drilling a 4 inch hole in the top of the freezer can I just drill 4 holes that are slightly larger then the tubing OD and shove each tap hose through each hole? Is there anything wrong with this?
Thanks.