CCBrewer
Well-Known Member
I have been searching for the last 3 days for other threads on high pressure propane aetups using pid controlled solenoids and a manual needle valve for the pilot.
I am not a fan of low pressure and will be using my stand for frying fish as well as crawfish broils. Different pots
My question is this other than the solenoids and needle valves what else is needed plumbing wise for the gas side? I will have a master ball shutoff on the junctions and needle valves after the solenoids for fine control.
Is there anything else I'm missing?
I am not a fan of low pressure and will be using my stand for frying fish as well as crawfish broils. Different pots
My question is this other than the solenoids and needle valves what else is needed plumbing wise for the gas side? I will have a master ball shutoff on the junctions and needle valves after the solenoids for fine control.
Is there anything else I'm missing?