capulinflicker
Active Member
So I had a little DIY project here to make an immersion wort chiller from copper tubing. It turned out pretty good, but unfortunately the pipe bending tool I bought ended up putting some scratches in the copper. How concerned should I be about this leading to infection if I use it to cool my wort? I usually have a 3 gallon bucket of Star-san ready to go in order to give everything a good soak. If I let the chiller have a good soak before putting it in the wort will that be sufficient to use the chiller despite the scratches in the tubing?
I just hope I didn't throw $30 down the drain
I just hope I didn't throw $30 down the drain