So, I'm about to venture down the keezer road and I have a few questions... I have my kegs, freezer, and temperature controller.
1. What is the desired height and depth of the coffin? I know it needs to be tall enough to support whatever glass I fill up, but is there any other considerations?
2. I see where the tops of these things can be pretty heavy. Does the entire thing rest on the freezer's seal or the side walls of the wooden cabinet?
3. How do you all attach the top to the freezer's lid? I've seen T-nuts, washers, etc...
4. CO2 tank... inside or out? Is there an advantage either way? Currently, mine is in the beer fridge w/ my kegs. My thoughts were to put it behind (or hide it outside) of the keezer and pipe in the gas to a manifold.
5. If the CO2 is outside, do you drill through the wall of the freezer or run the line through a collar?
Thanks,
Eric
1. What is the desired height and depth of the coffin? I know it needs to be tall enough to support whatever glass I fill up, but is there any other considerations?
2. I see where the tops of these things can be pretty heavy. Does the entire thing rest on the freezer's seal or the side walls of the wooden cabinet?
3. How do you all attach the top to the freezer's lid? I've seen T-nuts, washers, etc...
4. CO2 tank... inside or out? Is there an advantage either way? Currently, mine is in the beer fridge w/ my kegs. My thoughts were to put it behind (or hide it outside) of the keezer and pipe in the gas to a manifold.
5. If the CO2 is outside, do you drill through the wall of the freezer or run the line through a collar?
Thanks,
Eric