Fizzycist
Well-Known Member
So I'm contemplating this brew kettle and adding valve and sight gauge because it seems cheaper than a buying one all together.
http://http://spikebrewing.com/collections/15-gallon-stainless-kettles/products/15-gallon-stainless-3-couplers
My question is, can I use one of the installed NPT couplers as the ... port, for lack of a better word, for a 4500 w heater element? I can't make heads or tails of the various connectors that make it water tight. Also, would you recommend the element be in the middle or the bottom?
http://http://spikebrewing.com/collections/15-gallon-stainless-kettles/products/15-gallon-stainless-3-couplers
My question is, can I use one of the installed NPT couplers as the ... port, for lack of a better word, for a 4500 w heater element? I can't make heads or tails of the various connectors that make it water tight. Also, would you recommend the element be in the middle or the bottom?