jybingbrew
Well-Known Member
I am looking to make a 1L starter, and have a 3L Erlenmeyer Flask that will be on a stir plate. The 1L mark is pretty low on this relative to total height -- is there going to be any issues with how much surface area there is in terms of it drying out too much over a few days?
Will it make it difficult to decant after cold crashing?
Don't want to have to get a smaller size flask if not needed -- I would think this ratio would work, but if anybody else has similar experience or thoughts on the matter - would love to hear them. Thanks!
Will it make it difficult to decant after cold crashing?
Don't want to have to get a smaller size flask if not needed -- I would think this ratio would work, but if anybody else has similar experience or thoughts on the matter - would love to hear them. Thanks!