ExHempKnight
Well-Known Member
Which is better?
I'm putting my element together. I was originally planning to drill a hole next to the hot lugs, and solder the ground wire into it. I would then pot the whole thin into a pvc coupler with JBWeld.
However, this doesn't seem nearly as easy as potting just the hot wires, keeping the ground wire separate, and connecting the ground wire to a welded ground lug on the kettle.
Is there a difference (electrically)?
I'm putting my element together. I was originally planning to drill a hole next to the hot lugs, and solder the ground wire into it. I would then pot the whole thin into a pvc coupler with JBWeld.
However, this doesn't seem nearly as easy as potting just the hot wires, keeping the ground wire separate, and connecting the ground wire to a welded ground lug on the kettle.
Is there a difference (electrically)?