I'm visiting my dad and he's had an Avanti single tap tower kegerator that has been a foamer ever since he's owned it. While I'm down here I'm looking to fix this for him. It's set up for commercial kegs so the diameter of the beer hose is probably 5/8" and it about 5 or 6' in length.
The temperature is 41 degrees when taking the temp of a beer pulled. He has his gas pressure at 6psi, which I definitely know is too low.
My thought is that he's getting foam because his gas pressure is too low and co2 is coming out of suspension and filling in the tube.
He typically gets sixtals of fosters etc. Should his gas be set at 12lb psi based on the beer hose size? How can i help him?
The temperature is 41 degrees when taking the temp of a beer pulled. He has his gas pressure at 6psi, which I definitely know is too low.
My thought is that he's getting foam because his gas pressure is too low and co2 is coming out of suspension and filling in the tube.
He typically gets sixtals of fosters etc. Should his gas be set at 12lb psi based on the beer hose size? How can i help him?