Hey,
So I installed a weldless sight gauge (Fermentap) on my keggle a while back. Apparently the spot I chose was at a slight angle, which didn't seem to be that steep. When I put the sight gauge on, however, it is away from the keg by several inches on the top... I would say it is 5 degrees or so from the vertical... Does anyone have any good suggestions to straighten it up?
-Eric
So I installed a weldless sight gauge (Fermentap) on my keggle a while back. Apparently the spot I chose was at a slight angle, which didn't seem to be that steep. When I put the sight gauge on, however, it is away from the keg by several inches on the top... I would say it is 5 degrees or so from the vertical... Does anyone have any good suggestions to straighten it up?
-Eric