AHammer16
Well-Known Member
Here are the O ring numbers for the corny kegs I have. I would assume that they are standard to all cornys. However I cannot find the right one for the lid seal Does any one know what it is supposed to be?
O-rings on the ball lock (outside on the connector)
#9 o-ring 5/8 x 7/16 x 3/32
O-rings on the down tubes(inside and underneath the valve assembly)
#83 o-ring 1/2 x 5/16 x 3/32
O-ring for the lid seal.
? Any one know? I think it has an I.D. of 3 1/2 inch and a thickness of 1/4 inch but I cant find it.
O-rings on the ball lock (outside on the connector)
#9 o-ring 5/8 x 7/16 x 3/32
O-rings on the down tubes(inside and underneath the valve assembly)
#83 o-ring 1/2 x 5/16 x 3/32
O-ring for the lid seal.
? Any one know? I think it has an I.D. of 3 1/2 inch and a thickness of 1/4 inch but I cant find it.