inhifistereo
Well-Known Member
I purchased a Haeir kegerator off of craigslist a few weeks ago complete with 5 lb CO2 tank. I wanted to add a few more kegs to my setup so I purchased a secondary regulator from Micromatic along with a 3-tap tower. I installed the secondary regulator with approximately 2.5 feet of hose between the primary and secondary regulator. Then ran 5 feet of gas hose from each secondary connection.
Last night I set the primary regulator psi to 21.
Then set each secondary to 10 psi. This morning I woke up and my primary is holding rock solid at 21 but my secondaries have all fallen way below 10 psi.
What is my issue here? Is it because the secondary regulator is laying down? Is 5 feet too much hose to my gas-in post? Or is it because I don't have a keg hooked up yet?
I would assume that if the secondary's pressure fell that the primary would as well. Wrong assumption?
Last night I set the primary regulator psi to 21.
Then set each secondary to 10 psi. This morning I woke up and my primary is holding rock solid at 21 but my secondaries have all fallen way below 10 psi.
What is my issue here? Is it because the secondary regulator is laying down? Is 5 feet too much hose to my gas-in post? Or is it because I don't have a keg hooked up yet?
I would assume that if the secondary's pressure fell that the primary would as well. Wrong assumption?