adamjab19
Well-Known Member
I am just about to finish my cooler to MLT conversion and I am doing the SS braid setup.
On flyguy's tutorial he mentions some vinyl tubing to place in for support. I think I found it at my local ACO. It says vinyl (PVC) tubing safe for potable water but not ice machines. The packaging also states that it is good up until 175*F and I think 50psi or so. It seems like my keg tubing that I have. It comes in a 10' package so I could use what I need for the braid and then the rest can be used outside the cooler.
OR
Do I get the stiff white ice machine tubing?
OR
Just reuse the tube I just pulled out of the SS braid, notch it, and out it back into the braid?
Thanks in advance.
On flyguy's tutorial he mentions some vinyl tubing to place in for support. I think I found it at my local ACO. It says vinyl (PVC) tubing safe for potable water but not ice machines. The packaging also states that it is good up until 175*F and I think 50psi or so. It seems like my keg tubing that I have. It comes in a 10' package so I could use what I need for the braid and then the rest can be used outside the cooler.
OR
Do I get the stiff white ice machine tubing?
OR
Just reuse the tube I just pulled out of the SS braid, notch it, and out it back into the braid?
Thanks in advance.