So, i made a herms setup, 3 tier, all that.
My problem is that even after running auto tune, i will over shoot every single time, and not even by a little, by alot.
I think i know my problem is that my herms coil is too small diameter as I only used some scrap copper i had lying around.
Can a herms expert help me pinpoint what I need to change to get better mash temp? I'm really not sure where to start.. but I'm running an 120v system.
My problem is that even after running auto tune, i will over shoot every single time, and not even by a little, by alot.
I think i know my problem is that my herms coil is too small diameter as I only used some scrap copper i had lying around.
Can a herms expert help me pinpoint what I need to change to get better mash temp? I'm really not sure where to start.. but I'm running an 120v system.