I just found a "Brand New" Single-Phase AC Motor in the basement from my Father-in-law , honestly it has never been used but it from the 70's. The manufacture is Daytona. I wired it up and it runs fine but I have two questions before I by a pully for it and my grain mill shaft (belt too):
First: Single phase is not the strongest of the AC Motor group , Is it strong enough based off of your experiences?
Second: Can you put a variable control on the electric feed to maintain desire RPM's?
and since its Friday night I am enjoying a Sx Points Resin Prost!
Some Edits/Updates:
Its Dayton not Daytona
1/3 HP 1725 RPM 115V 5.4 AMP 60 Mz
First: Single phase is not the strongest of the AC Motor group , Is it strong enough based off of your experiences?
Second: Can you put a variable control on the electric feed to maintain desire RPM's?
and since its Friday night I am enjoying a Sx Points Resin Prost!
Some Edits/Updates:
Its Dayton not Daytona
1/3 HP 1725 RPM 115V 5.4 AMP 60 Mz