I'm building a e-Herms and when I plug my pannel, it always trips. I tried to unplug everything from the blocks inside the pannel. So the breaker is working fine. As soon I a plug back a single PID or a "120v to 12v transformer", the breaker is tripping.
I started using P-J's wiring diagram that I adapted to my equipment. I'm using my 50A GFCI spa breaker pannel. I put an RV 50a plug after that pannel, so I can unplug my spa and plug my e-Herms. My spa is working fine, so I'm sure the problem is in my herms pannel.
I also tried to plug a 120v wire to the line 1 and neutral before plugging it into the spa pannel and everything was working fine!!
Here is my mod of P-J's wiring diagram:
I started using P-J's wiring diagram that I adapted to my equipment. I'm using my 50A GFCI spa breaker pannel. I put an RV 50a plug after that pannel, so I can unplug my spa and plug my e-Herms. My spa is working fine, so I'm sure the problem is in my herms pannel.
I also tried to plug a 120v wire to the line 1 and neutral before plugging it into the spa pannel and everything was working fine!!
Here is my mod of P-J's wiring diagram: