doggage
Well-Known Member
Quick question for anyone who has set up a chest freezer with a Love Controller. My controller is a Love TSD-10110. I'm trying to get it set up with my chest freezer.
My hot supply line is going to terminal 6. My neutral supply line is spliced and goes to terminal 7 as well as on to the compressor. I didn't know what to do with the supply ground, which was previously screwed to the stock thermostat. So I just screwed the supply ground to the freezer frame. I put a jumper between 6 and 8. Then I have a (switched?) hot line coming out of 10 and on to the compressor. My temp probe's blue line is on terminal 2 and its brown is on terminal 4.
When I plug in, my controller is alternating between an "Erp" code and the probe temperature. The controller also isn't kicking on the compressor. I'm not sure if setting the temp is more complicated than hitting set and using the up and down arrows, but this is having no effect. Thanks! - Anthony
My hot supply line is going to terminal 6. My neutral supply line is spliced and goes to terminal 7 as well as on to the compressor. I didn't know what to do with the supply ground, which was previously screwed to the stock thermostat. So I just screwed the supply ground to the freezer frame. I put a jumper between 6 and 8. Then I have a (switched?) hot line coming out of 10 and on to the compressor. My temp probe's blue line is on terminal 2 and its brown is on terminal 4.
When I plug in, my controller is alternating between an "Erp" code and the probe temperature. The controller also isn't kicking on the compressor. I'm not sure if setting the temp is more complicated than hitting set and using the up and down arrows, but this is having no effect. Thanks! - Anthony